Cables
There are a few different designs in cable connectors as was mentioned in the Connections Page. But this section will cover the wires that send power and data to the controllers and the lights.
Power Injection
Power injection cables are an easy way to extend the power to more pixels on a strand or multiple strands on one port. There are a few different types, but the best kind are the ones that only have power and ground at the T, this makes it eaiser so you don't pull out the data pin on the T or the power cable.
F-Amp/Null/Boost
F-Amp – The F-Amp can be attached directly to the pixel controller or can be placed some distance away from controller.
Null Pixel – Each pixel serves as a re-transmitter of the data signal. A pixel is called a Null Pixel when it is used solely as a re-transmitter for distance and not actually mapped to any models in the display. This is configured in the controller so it essentially ignores that pixel.
uAmp – The uAmp is a signal conditioner that cleans up the data, allowing it to fither transmiton distances than a null pixel. This can get about 60-70 ft between pixels. These operate without the need to configure the controller.